12-18-NV E-ZEE 3D FOAM 3mil

12-18-NV E-ZEE 3D FOAM 3mil

#12-18-NV E-Zee 3D Foam 3mil, Madeira topping
12-18-NV

Product Description

12inX18in 1pc NAVY



E-Zee 3D puff embroidery foam is 3mm thick.

This material is intended for use with designs that have been digitized for raised, 3D embroidery on stable fabrics. Great for caps, jackets, bags, aprons and other stable fabrics. Designs must be digitized specifically for 3D Embroidery. Available in many different colors to best match thread colors

Specifications:

  • E-Zee 3D puff embroidery foam
  • Navy
  • 3 mm
  • 12" x 18" sheet
  • 1 sheet

Use with:

  • Caps
  • Bags
  • Aprons
  • Letters
  • Monograms
  • Raised embroidery effect
  • Dark colored embroidery thread

How to use:
It is best to insert a stop in the design after the flat part of the embroidery is done and before the raised part of the embroidery is started. Cut a piece of E-Zee 3D Puff Foam large enough to cover the area to be stitched. When the machine stops and is ready for the foam,lay the foam over the area to be stitched inside the hoop. Tape the edges of the foam to hold it down. You may use a spray adhesive as an alternative. Continue stitching the design. Remove the excess foam by tearing away. Tweezers are helpful for the small areas that need to be removed. Use a pointed object to poke in any small pieces of foam that remain and are sticking out of the design. You may also use a heat gun to shrink them into the design. Be careful not to set the temperature too high  to avoid burning the thread.
 

DOCUMENTS & INFORMATIONAL SHEETS

E-Zee 3D Puff Foam Instructional sheet.pdf

How to Create 3D Embroidery .pdf

Available Combo Deals